Mylex eXtremeRAID Installation Guide download pdf (Page 26)

Installation Checklist

2-4 eXtremeRAID 3000 Installation Guide

Installation Checklist

GET READY

☛ Note

It is recommended that you wear a grounded wrist

strap when working with hardware installation

procedures.

1. ____ Decide which available PCI slot will be used.

2. ____ Remove the plate from the I/O access port to the PCI slot.

3. ____ Remove the eXtremeRAID 3000 controller from the anti-static

bag.

GET SET

4. ____ Plug the eXtremeRAID 3000 controller into a standard PCI slot.

5. ____ Tighten the eXtremeRAID 3000 controller into the mounting

bracket.

6. ____ Connect the SCSI cable from SCSI drive(s) and/or SCSI

device(s) to the internal SCSI channel.

7. ____ Check termination - only for the internal SCSI channel.

8. ____ Check disk drives. Be sure termination is set to the disabled

position on any disk drive(s) that will not be terminated. For more

information, see the documentation that accompanied the disk

drives.

9. ____ Set SCSI ID on the SCSI disk drive(s).

10. ____ Enable termination power on SCSI disk drive(s).

11. ____ Insert the Fibre disk drives into a Fibre Channel Cabinet.

12. ____ Connect the Fibre HSSDC cable from the Fibre drive(s) to the

external Fibre loop channel(s).

☛ Note

Use only Fibre disk drives in your Fibre Channel

Cabinet.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 89 90

No comments

Mylex eXtremeRAID Installation Guide Page 26