Manual No. 775031 1
Hardware
Introduction
The eXtremeRAID 1100 (DAC1164P) is a very versatile PCI to Ultra2
SCSI, LVD RAID controller. There are thousands of possible hardware
configurations. The following parameters are assumed:
• A RAID 0, 1, or 5 configuration is being installed.
• The user is familiar with Windows NT
®
or Novell
®
NetWare
®
.
• The user is familiar with disk drive and RAID terminology.
Performing an Installation
,
WARNING
To avoid electrical shock, do not attempt to
perform this hardware installation with power on.
Disconnect the system from the electrical wall
outlet.
Connectors, Jumpers, and LEDs
Up to three Ultra2 SCSI channels are supported on the controller. The SCSI
connector locations are shown in Figure 1.
All the jumpers should normally be set to their (default settings). See Table 1
for default jumper settings. Jumper locations are shown in Figure 1.
The controller has 15 LEDs that are active indicators while the controller is
running. The LEDs indicate termination type and status, SCSI activity, cache
status, diagnostic status, and host activity. The LED locations and meanings
are shown in Figure 1.
Comments to this Manuals